24
NOTE: The rear brake must be held for the starter motor
to engage the engine. It is normal for the stop light to be
illuminated during starting.
5. Allow a cold engine to warm 2 - 3 minutes before riding.
OPERATION
Starting the engine (electric start)
To start your scooter using the electric starting motor, follow
this procedure:
1. Unlock the steering with the igntion
switch key 1
2. Turn the igntion switch to “ON“.
NOTE: Before starting, check the en-
gine oil and fuel levels. Take the
scooter off of the main stand.
3. Apply the rear brake 2 (left lever) .
The brake must be adjusted and functioning properly
to lock the rear wheel during starting or the scooter
could accelerate away when the engine starts.
To prevent damage to the starter motor, do not operate
the starter motor for more than five seconds at a time. If
the scooter fails to start immediately, check the fuel level
and the battery condition, and allow the starter motor to
cool before attempting to start the engine again.
4. Press the starter button 3 without rotating the throttle grip.
NOTE: If the scooter’s engine is warm and does not start
immediately, rotate the throttle grip 1/8 to 1/4 open to help
the engine start.
11
11
1
22
22
2
33
33
3
To Next Page
Loading...
Need help?
General
