6-3
KC-GL pen width
a
G1 through G8 0 to 99 dot 01/02/03/04/
05/06/07/08
Interface release time-
out
J2 0 to 99 in units of 5 seconds 6
KC-GL enlarge mode
a
J9 0: Off 0
1: A2
2: A1
3: A0
4: B3
5: B2
6: B1
7: B0
Duplex mode N4 0: Simplex mode 0
1: Long-edge binding
2: Short-edge binding
Default emulation
mode
P1 0: Line Printer 6
1: IBM Proprinter X24E
2: Diablo 630
5: Epson LQ-850
6: HP LaserJet
8: KC-GL
9: KPDL
Carriage-return action P2 0: Ignores 0x0d 1
1: Carriage-return
2: Carriage-return+linefeed
Linefeed action P3 0: Ignores 0x0d 1
1: Linefeed
2: Linefeed+carriage-return
Automatic emulation
sensing
d
P4 0: AES disabled 0
1: AES enabled
Alternative emulation P5 Same as the P1 values except that 9 is ignored. 6 (HP LJ)
Automatic emulation
switching trigger
P7 0: Page eject commands 10
1: None
2: Page eject and Prescribe EXIT
3: Prescribe EXIT
4: Page eject commands
5: Formfeed (^L)
6: Page eject, Prescribe EXIT and formfeed
7: Prescribe EXIT and formfeed
8: Page eject commands; if AES fails, resolves
to alternative emulation (P5)
9: None; if AES fails, resolves to alternative
emulation
10: Page eject commands; if AES fails, resolves
to KPDL
Emulation switching
after receiving !R!
P8 0: Current emulation
1: Default emulation (P1)
2: Alternative emulation (P5)
Sorter sharing S0 0: Stand alone
1: Multi users
2: Multiple interfaces
Sorter mode S1 0: Sorter 0
1: Collator
2: Stacker
3: Mailbox
Sorter message S2 0: Remove sorter paper messaged 0
1: Remove sorter paper deactivated except at
power-up
2: Remove sorter paper deactivated
Sorter overfilling
behavior
S3 0: Interrupts printing until trays are emptied
1: Bypasses printing to the face-down tray
0
Job separate mode S8 0: Whole pages
1: 1st page only
0
Line spacing
a
U0 Lines per inch (integer value) 6
Line spacing
a
U1 Lines per inch (fraction value) 0
Character spacing
a
U2 Characters per inch (integer value) 10
Table 6.1. Interface-dependent Parameters (Sheet 2 of 3)
Environment Parameter Value Factory setting
To Next Page
Loading...
Need help?
General