Settings Pages
on secure protocol, see Advanced > Security > Secure Protocols on page 6-
49.
Advanced > Protocols > AppleTalk
You can print from Macintosh computers using the AppleTalk protocol.
Appletalk protocol is available in OS 10 versions 10.5 and below. Appletalk is no
longer supported in Mac OS version 10.6.
The printing system network component supports Mac OS of various versions
(Web Browser on page 1-1) and is compatible with LaserWriter driver version
8.x.
To set up the Ethernet interface to communicate via AppleTalk, enable
AppleTalk protocol operation on the printing system.
AppleTalk
Enables or disables AppleTalk protocol.
Printer Name
Specifies the name of the printing system in the AppleTalk network.
Zone Name
Specifies the name of the AppleTalk zone (network). An asterisk (*) means
the default zone.
Advanced > Protocols > NetBEUI
Peer-to-peer printing (SMB Print) is available using NetBEUI protocol. With this
method, the printing system is located in Windows Network Neighborhood.
NetBEUI is an enhanced version of the NetBIOS protocol, which is used for
transport of SMB protocol.
NetBEUI Protocol
Enables or disables NetBEUI protocol. If NetBEUI is turned On, name
resolution via NetBIOS (NMB) can be used.
Printer Name
Printer Name correlates with Host Name in the TCP/IP General page (Refer
to Advanced > Protocols > TCP/IP > General on page 6-32). If you want to
change the NetBEUI printer name, change the TCP/IP Host Name.
Workgroup
Workgroup represents the workgroup which will appear in Entire Network in
"Windows Network Neighborhood."
Comment
You can enter comments here. (This can also be left blank.)
Advanced > E-mail > SMTP > General
Device event reports and counter status such as Low Toner and other
information can be sent automatically via E-mail to the specified E-mail address.
To use the mail function, configure SMTP (Simple Mail Transfer Protocol) to
connect this device to an E-mail server.
SMTP
Enables or disables SMTP protocol. To use E-mail, this protocol must be
enabled.
SMTP Port Number
6-38 User Guide
To Next Page
Loading...
Need help?
General