Appendix
A-16
Special Paper
The following types of special paper can be used:
Use paper that is sold specifically for use with copiers or printers (heat-fusing type). When using labels, thin paper,
postcards, or thick paper, feed the paper from the MP tray. For details, refer to MP Tray Set. (MP tray settings) on page 4-30.
Since the composition and quality of special paper vary considerably, special paper is more likely than white bond paper to
give trouble during printing. No liability will be assumed if moisture and so forth given off during printing on special paper
causes harm to the machine or operator.
Transparency
To prevent printing problems, feed transparencies into the printer one
sheet at a time from the MP tray. Always load the transparencies vertically
(with the long edge towards the printer).
If the transparencies have rough edges on the back, it may cause a paper
jam. Remove the rough edges, reverse the sides, feed the sheet from the
opposite edge, or flip the sheet over.
When unloading transparencies (e.g., for clearing jams), hold them
carefully by the edges to avoid leaving fingerprints on them.
Paper Type to be Used Paper Type to be Selected
Overhead projector transparencies Transparency
Rough paper Rough
Thin paper Vellum
Label Labels
Recycled paper Recycled
Preprinted paper Preprinted
Bond paper Bond
Postcards Cardstock
Colored paper Color
Prepunched paper Prepunched
Letterhead Letterhead
Envelopes Envelope
Thick paper Thick
High-quality paper High Quality
Custom Custom 1~8
Note Before purchasing any type of special paper, test a sample on the machine and check that printing quality is
satisfactory.