Preparation before Use
2-16
20Press [Next] ([Right Select]).
The network between this machine and the computer or handheld
device is configured.
IMPORTANT You can connect up to three handheld devices at
the same time using Wi-Fi Direct setting. When the devices that
support Wi-Fi Direct are connected, if you want to connect other
device, disconnect the alreadyconnected devices from the
network. The disconnection methods are as follows:
• Disconnect the network from the computer or handheld computer
• Disconnecting all devices from the network on the operation panel
(ConnectionStatus...6-7)
• Configuring auto disconnecting time from the System menu
(Disconnect Timer (Setting the Disconnect Time)...4-63)
• Configuring auto disconnecting time from the Command Center
RX (Command Center RX User Guide)
Printing a Status Page
After completing the network settings, print a status page. The status page allows you to confirm a range of information,
including network addresses and network protocols.
To print a status page, select Report Print from the Report menu, and then select Status Page. Refer to Report
Print on page 4-10 for detailed information.