6-3
Maintenance
Replacing the Toner Container
This section explains how to replace the toner container.
1 Open the front cover.
2 Pull out the toner container.
3 Take the new toner container out of the toner kit. Shake the new toner container at least 10
times as shown in the figure in order to distribute the toner evenly inside the container.
CAUTION Do not attempt to incinerate the Toner Container. Dangerous sparks may cause burns.
IMPORTANT During toner container replacement, temporarily move storage media and computer supplies (such as
floppy disks) away from the toner container. This is to avoid damaging media by the magnetism of toner.
KYOCERA Document Solutions Inc. is not liable against any damages or problems arising from the use of toner
containers other than those designated as original Kyocera toner containers. For optimum performance, it is also
recommended to use only the Kyocera toner containers which are specifically intended for use in your country or
region. If the toner container for another destinations is installed, the machine will stop printing.
Note You do not have to turn machine power off before starting the replacement. Any data that may be processing
in the machine will be deleted if you turn the machine power off.
Note Put the old toner container in the plastic bag (supplied with the new toner kit)
and discard it later according to the local code or regulations for waste disposal.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
