EasyManuals Logo
Home>Kyocera>All in One Printer>FS-2100DN

Kyocera FS-2100DN User Guide

Kyocera FS-2100DN
82 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #28 background imageLoading...
Page #28 background image
Settings Pages
This allows you to verify the accumulated number of printed pages for each
paper size and color (Monochrome, Mono Color, and Full Color). A page
printed on both sides is counted as two pages.
Counters > Scanned Pages
Provide information of the number of pages copied, faxed, and other
(scanned), respectively.
Start > Information
This page provides information about user account.
User Login
This shows the number of registered users. For details, see Basic > Security
> User Login on page 6-10.
Basic Page
This section includes settings that apply to the device, such as Device Defaults,
Security, and basic Networking.
Basic > Defaults > Network
This page allows you to make the settings that are required for network printing
and sending E-mail. For more information, refer to Advanced > Protocols >
TCP/IP > General on page 6-32.
You must restart the network or this machine after you have completed these
settings in order to properly register the content of those settings in the
machine. Refer to Basic > Defaults > Reset on page 6-6.
Host Name
Specifies a name for the printing system network component. This name is
used as the NetBEUI printer name and as the WSD device name.
LAN Interface
Specifies the communication rate from Auto, 10BASE-T-Half, 10BASE-T-
Full, 100BASE-TX-Half, 100BASE-TX-Full and 1000BASE-T.
IPv4 Settings
DHCP/BOOTP
Specifies whether or not to obtain an IP address using DHCP or BOOTP.
IP Address (IPv4)
Assigns the Internet Protocol address on the printing system network
component. Format of the IP address is four-byte (32-bit) numbers separated
by dots, for example, 192.168.110.171.
Subnet Mask
Specifies the subnet mask of the hosts or network with which the print system
is connecting. If you have manually assigned an IP address that starts with a
number between 192 and 223, it is recommended that you set the subnet
mask to "255.255.255.0."
Default Gateway
Specifies the IP address of the default gateway.
IPv6 Settings
IPv6
6-4 User Guide

Table of Contents

Other manuals for Kyocera FS-2100DN

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera FS-2100DN and is the answer not in the manual?

Kyocera FS-2100DN Specifications

General IconGeneral
BrandKyocera
ModelFS-2100DN
CategoryAll in One Printer
LanguageEnglish

Related product manuals