EasyManuals Logo
Home>Kyocera>Printer>FS FS-9530DN

Kyocera FS FS-9530DN User Manual

Kyocera FS FS-9530DN
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
Maintenance
OPERATION GUIDE 3-3
Toner Container Replacement
The toner container in the printer should be replaced as soon as the
message display shows Toner low or soon after. If you continue to use
the printer, eventually the toner supply will be exhausted at which point the
printer will stop printing and the Replace toner Clean printer
message will be shown instructing you to install a new toner kit.
Frequency of toner container replacement
Assuming an average toner coverage of 5 % and EcoPrint mode turned
off, the toner container will need replacing approximately once every
40,000 pages.
Starter Toner Container
The toner container packed with the new printer is a starter toner container.
The starter toner container lasts an average of 20,000 pages.
Toner Kits
For best results, we recommend that you only use genuine Kyocera Parts
and Supplies.
A new toner kit contains the following items:
Toner Container
Cleaning cloth
Plastic waste bags for old toner container and old waste toner box
Waste toner box
NOTE: Be sure to clean the inside of the printer when replacing the toner
container.
Understanding Messages Requesting Toner Container Replacement
The printer displays messages at two stages of toner usage. This message
is automatically alternated with the other printer message (such as
Ready):
When the printer becomes low on toner, the printer displays the
message Toner low as the first caution. Note the replacement is not
always necessary at this stage.
If you ignore the above message and continue printing, the printer
displays the message Replace toner - just before the toner is used
up. The toner container must be replaced immediately. After the
cleaning is finished, however, the message does not
automaticallychange to Ready. To restart printing, you must press
[GO] and make the printer ready.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kyocera FS FS-9530DN and is the answer not in the manual?

Kyocera FS FS-9530DN Specifications

General IconGeneral
BrandKyocera
ModelFS FS-9530DN
CategoryPrinter
LanguageEnglish

Related product manuals