28
OPERATIONS
FOREWORD
During cooking (LED on steady) the displays
show the actual values (current status). It is
anyhow possible to check the settings. For
this purpose, proceed as follows:
15 • OPERATING DETAILS
15.1 • DISPLAYING SETTINGS DURING
COOKING PHASE (without stopping)
Press key 1, the displays blink showing the
previous settings. After 10 sec. the actual
values reappear (TIME OUT) so in general:
display blinking: value set.
display on steady: actual value.
15.2 • CHANGING THE SETTINGS DURING
THE COOKING PHASE
(WITHOUT STOPPING)
15.3 • TEMPORARY STOP
Open the door. Cooking stops, the time
remaining to the end of cooking stops
until the door is closed again. Cooking
starts again from the point in which it was
interrupted.
15.4 • PERMANENT STOP
To stop an infinite cooking time or interrupt
it definitively, press key 15.
15.2 a
•
TEMPERATURE AND
TIME
To change the setting,
turn the relevant knob
to set the new value
(increasing to the
right, decreasing to
the left); the displays
show the settings that
have just been made,
after 10 sec. the actual
values reappear.
15.2 b
•
COOKING MODE
Press the key
corresponding to the
new cooking mode. The
corresponding LED will
light up.
15.2 c
•
HUMIDITY CONTROL
Press the humidity
control function key 12
(the display shows [ h.. ],
the previous setting).
Turn knob 10 to make
the new setting. After 10
sec. the actual values
reappear.
15.2 d
•
CORE PROBE
To change the setting,
turn the knob 10 to set
the new value. After
the 10 seconds of
TIME OUT the actual
values reappear.
To Next Page
Loading...
Need help?
General