11
12.1 COOKING WITH THE CORE PROBE
Caution: If you select a program that
requires the core probe, connect the
core probe to the connection (10),
place the probe in its cylindrical
housing if the first cycle is used to
preheat the oven with no load.
Connect the probe to the connection
(10), insert the needle into the product
to be cooked.
Set the oven temperature and the
desired core temperature (as directed in
the chapters on cooking settings), using
the Scroller+.
What happens
The temperature in the oven increases
until it reaches the set temperature
and is then maintained at this level.
The product temperature increases
reaching the set core temperature, an
information window appears indicating
to give the operator time to organize
distribution.
an acoustic signal sounds and an
information window on the display
signals the end of cooking.
Caution:
inserting the core probe in connection
10 (the time it takes the electronic card
to identify the probe), then start cooking
with key 4 START/STOP.
If the probe is not identified, a
warning message to that effect
appears.
Press “BACK” (3), wait a few seconds
and start cooking by pressing the (4)
START/STOP key.
7.1 - POSITIONING THE CORE PROBE
Foreword
The core probe allows cooking to be
regulated by monitoring the temperature
at the core of the product. This device
overrides the time setting, and cooking
stops as soon as the temperature at
the core of the product reaches the
selected value.
Using the “multipoint” core probe,
with four sensor points, ensures the
temperature is reached at the core of
the product. In fact, end of cooking
is signalled when all of the probe’s
temperature sensors have exceeded the
set value.
7 COKING WITH CORE PROBE
Manual
01/
03
CYCLES
53°
130°
SET
170°
%
30
Before loading
preheat oven
ATTENZION
Core temp. Probe
!!
90027560rev00
To Next Page
Loading...
Need help?
General