The Manufacturer assigns two product identification numbers to each Oven/Steamer:
a model number and a serial number. The model number identifies the product
characteristics. The serial number identifies the individual unit (Figure 1-1).
MODEL NUMBER
This manual covers all models (for capacit in units): each model electric or gas-fired with
or without steam generators.
Each character of a model number identifies a characteristic of the oven/steamer.
The model number begins with CBE.. (with steam generator, “E” means electric) or
CVG.. / CVE.. or COE.. (without steam generator, “E” or “G” means electric or gas-fired),
followed by a number for capacity in units. This manual covers all standard features and
options available on the Oven/Steamer models listed above.
Other than selection of options, there are presently no significant design, parts, or
operating differences among oven/steamers with the same model number.
Figures 1-2 illustrate the models and identify the major components.
PRODUCT TAGS
Before shipping, each single unit is furnished with different tags which give you
information on appliance operation. These tags are located on the lower right side of the
unit close to the identification plate.
IDENTIFICATION PLATE
Figure 1-1 illustrates typical Identification Plates.
The plate is located on the right side of each unit as illustrated in Figures 2-1.
The Identification Plate lists the model number, gas supply requirement, power
requirements, and wiring requirements of each Oven/Steamer.
Figure 1-1. Identification Plate
CHAPTER 1. PRODUCT IDENTIFICATION
12
90028771rev00
To Next Page
Loading...
Need help?
General