PREVENTIVE MAINTENANCE AND TROUBLESHOOTING
NOTES
WARNING
DEATH, INJURY, OR ELECTRIC SHOCK can occur by touching electrical
components and wires inside the access panel when the main power switch is in
the ON position. NEVER REMOVE THE SERVICE ACCESS PANEL. Allow only by
Authorized Service Representatives to perform service, maintenance, and repairs
that require the removal of the service access panel(s).
All circuits in the oven/steamer stop working if unit overheats or motor is overloaded.
Call an authorized service representative.
All circuits in the oven/steamer stop working if the cavity or steam generator overheats
or the motor is overloaded. Call an authorized service representative.
If the problem is inside the oven/steamer, call an authorized service representative. The
manufacturer will not pay for warranty repairs by unauthorized repair centers.
Repairs to external wiring should be done by a Licensed Electrician.
Proper installation of the Oven/Steamer is the responsibility of the owner or installer.
Repairs to external plumbing should be done by a Licensed Plumber.
FOR THE ATTENTION OF THE AUTHORIZED SERVICE REPRESENTATIVE;
YEARLY CHECKING:
For all gas models the state of the metal components in direct contact with the source
of heat (burners flames) must be checked.
It is therefore advisable to make an annual visible check on the combustion chamber.
This precaution is sufficient to prevent irreparable damage to the appliance.
62
90028771rev00
1-
2-
3-
5-
6-
4-
To Next Page
Loading...
Need help?
General