- 70 -
24 • SELF-DIAGNOSIS AND ERRORS GUIDE
MESSAGES
The main error messages are:
A08
There is excessive overheating in the electrical
components compartment, which may compromise the
integrity of components. Immediately turn off the oven and
call the technical support service.
DOOR OPEN
Door appears open, which means the door micro-switch
contact is open. Make sure the door is closed properly, if the
error persists, call the technical support service.
A60 - A61 - A62
Steam generator malfunction
Immediately turn off the oven and call the technical support
service.
EXTRAORDINARY MAINTENANCE REQUIRED
This message appears when the device is turned off,
indicating the descaling cycle of the steam generator needs
to be run.
RUN CALOUT
This message appears when the device is turned off,
indicating the descaling wash cycle of the steam generator
needs to be run.
A05
It indicates that the water has not been drained from the
steam generator. If the error message appears during the
descaling “dE” programme, the device shuts down; call
the technical support service.
BOILER DISABLED
The boiler is disabled because the drainage procedure failed.
Call the technical support service.
A30 - A31 - A32 - A33 - A34 - A35 - A36 - A37
Inverter malfunction
Immediately turn off the oven and call the technical support
service.
WARNING FOR GAS MODELS
A06
No gas Check that the gas tap is open and gas being
supplied. If the lack of gas depends on the supply, inform
the utility service. If, however, gas being supplied, call the
technical support service.
A21 - A23 - A25 - A27
Gas devices are fitted with an ignition device, with automatic
re-ignition. If the automatic re-ignition function does not
work after a few attempts, display 15 shows error code A21
- A25 for cooking chamber burners or A23 - A27 for boiler
burners.
An acoustic signal notifies the operator. Press knob 14 to
re-ignite. If the problem persists, call the technical support
service.
Note: a blocked burner is a safety measure, therefore this
situation is not an indication of an oven malfunction.
If after carefully performing the above checks the oven
still doesn't work properly, call the authorised technical
support service.
Note: when technical support is requested, provide as many
details as possible about the defect and all the information
shown on the identification plate.
A20 - A22 - A24 - A26
Burner Alarm
Immediately turn off the oven and call the technical support
service.
90037450rev00