Launch J2534 User Manual

LAUNCH Smartbox 3.0-J2534 Operation Manual
3 / 15
1 Connection of Smartbox3.0
Smartbox3.0 comes with a USB cable.
One end of Smartbox3.0 is connected to the USB cable: one port of the USB cable is connected to
Smartbox3.0; the other port is connected to a USB port of a PC; the other end of Smartbox3.0 is
connected to the OBD interface bus, and the other port of the bus is connected to the OBD
connector.
2 Installation of Software Package and
Driver
2.1 Installation Steps of Software Package
2.1.1 Installation Steps of Software Package
Attention：Please ensure that the PC user has administrator
rights and Smartbox3.0 has been connected to a PC before
installation.
Step 1: Open "SmartBox_3.0_Setup.exe", and select the installation path according
to prompts
Step 2: Click 'Change' to select the installation path, and then click 'Next'

Launch J2534 Specifications

General

Brand	Launch
Model	J2534
Category	Diagnostic Equipment
Language	English