GENERAL INFORMATION
Machine identification information is printed on the data plate on the rear of the machine
(Fig.1). Overall machine dimensions:
Height: 1060 mm Width: 500 mm
Depth: 520 mm Weight: 80 Kg
Like any equipment with moving parts, the machine inevitably produces noise. The
construction system, paneling, and special provisions adopted by the Manufacturer are such
that during work the average noise level of the machine is not in excess of 70 dB (A).
END-OF-LIFE
The symbol on the right indicates that in accordance with Directive 2002/96/EC
the machine may not be disposed of as ordinary municipal waste but must be
delivered to a specialized center for separation and disposal of WEEE (Waste
Electrical and Electronic Equipment) or be returned to the dealer in case of
purchase of a new machine. Current legislation provides severe sanctions in the
case of disposal of WEEE into the environment. If improperly used or disposed of
into the environment, electrical and electronic equipment can release substances dangerous
for the environment and for human health.
SAFETY RULES
The machine designed for use in recovering the R134a refrigerant fluid used in the air-
conditioning (A/C) systems of motor vehicles. The machine is designed to be used by
qualified personnel only; moreover, correct use of the machine will depend on the operator’s
knowledge of the information contained in this manual, including the basic safety rules set
forth below: Wear protective gloves and goggles. Do not expose the machine to direct sunlight
or rain. Use only in well-ventilated work areas. Before performing any operation, check the
vehicle use and maintenance manual for the type of refrigerant fluid used by the A/C system.
Do not smoke in proximity to the machine while it is in operation. Do not use the machine in
proximity to sources of heat, open flames, or sparks.
Check whenever the engine is turned off that the ignition key is turned to the full OFF position.
Always close all the valves on the machine before connecting it to the A/C system of the
vehicle. Connect only the machine hose supplied with the RED quick-connect coupling to the
high-pressure branch of the A/C system. Connect only the machine hose supplied with the
BLUE quick-connect coupling to the low-pressure branch of the A/C system. Keep the
connection hoses away from moving parts and rotating elements such as cooling fans,
alternators, etc. Keep the connection hoses away from hot objects and elements such as
engine exhaust pipes, radiators, etc. Fill the A/C system with the quantity of refrigerant
recommended by the manufacturer. Never exceed said quantity. Check the oil levels at the
beginning of each operation. Always top up with the correct quantity of oil. Before connecting
the MACHINE, check that voltage and frequency of main electrical supply match the value
shown into the CE label.
Never fill the bottle to more than 80% of maximum capacity in order to leave an
expansion chamber for absorbing any pressure increases.
Never touch the valves on the refrigerant bottle installed on-board the MACHINE. Dispose of
the oil extracted from the A/C system and from the vacuum pump in suitable containers for
used oils. Replace the filters punctually at the prescribed replacement times. Use only filters
recommended by the manufacturer. Use only the oils recommended by the manufacturer.
Take care never to use the vacuum pump oil in the A/C system, or vice-versa. Failure to
www.diagtoools.lv
Diagtools LTD
To Next Page
Loading...
Need help?
General
