8 of 35 9 of 35
Menu Screens – for details of menu screens see under Section 2.7 Menu.
2.5 Operation
After the initial setup, M3+ is ready for operating in most Modes.
To select a Mode, press source until the required Mode splash screen is
displayed. After a brief moment M3+ switches to that mode. The last station or
track previously used in that mode is selected. If this is not possible, M3+
scans for relevant stations, networks, or prompts the user for appropriate
input. See the relevant Mode section for details of how to use each listening
mode.
The Common local controls for sound volume, Mute and Play/Pause are
available in all listening modes.
2.6 Menu navigation
The primary control for moving through menus and options is the Select
Control. Rotate the control to move up or down a menu. Once the required
option or value is highlighted press the Select Control. All menus and lists act
as loops such that turning the control to go beyond the first or last entry in a
menu or list takes you to the opposite end of the menu or list. So going up from
the first entry in a menu will take you to the last option in the menu, etc.
A “>” appears on the right of the screen if there are more options above
or below those visible.
To enter the menu tree in a particular mode press Menu. To move back a menu
level press Back . To exit the menu system, press Menu again. Each mode has
a Mode menu, with options specific to that mode.
For example, the FM mode menu has two mode specific options: Scan setting
and Audio setting.
In addition, each mode menu has two final options: System settings > and
Main menu >. The ">" indicates options leading to further menus.
The System settings menu presents system setting functions to allow the user
to setup how the unit behaves. This includes Equalizer, network,time/date,
language, factory reset and software update…….
The Main menu presents an alternative method for selecting listening modes
plus sleep and alarm functions.
3. Started and setup
M3+ is easy to use. To play DAB or FM radio, all you need is a power source (a
100-240 V mains supply); For Music Player mode, you need a wired/wireless
Ethernet network and a UPnP music server (e.g. a PC). For Internet-
connected modes such as Internet radio, you also need a broadband Internet
connection.
3.1 Setup wizard
When M3+ is started for the first time, it runs through a setup wizard to
configure settings for date/time and network. Once this has finished, the
system is ready to use in most modes.
Note: To change these settings later, select Menu > System settings >.
To run the setup wizard again, select Menu > System settings > Setup wizard.
Select Yes to start the setup wizard.
If you choose No, the next screen asks if you would like to run the wizard next
time M3+ is started. The system then starts without configuring time/date and
network settings and enters the Main Menu.
Note: If power is removed while the wizard is in progress, the wizard will run
again next time M3+ is started.
3.1.1 12/24 hour display
To change between 12 and 24 hour display, select Set 12/24 hour and then
select your preference.
3.1.2 Set Time/Date (wizard)
To Next Page
Loading...
Need help?
General
