7.1 Selecting stations
To find a station, press Select. The frequency display starts to run up as MSY5 scans
the FM band. Alternatively, you can scan up or down by pressing and holding the >> or
<<buttons or tune manually with quick presses, or by turning the Select control.
Presets to store an FM preset, press and hold button P
res set until the display
shows the Save preset screen. Select one of the 20 presets to save the currently
playing station.
To select a preset, press P
res set briefly, then select one of the listed Preset stations.
When a preset station is playing, it shows
1,2,3 etc in the bottom middle of the
screen.
7
.2 Now playing information
While an FM station is playing, the screen shows one of the two following sets data:
If RDS information is available, by default the service name (i.e. station name) is
displayed.
You can cycle through further RDS information by pressing I
nfo .Each time you press
I
nfo, another set of information is displayed, cycling through RDS radio text, RDS
programme type, frequency and today’s date.
If no RDS information is available, the currently tuned frequency is shown.
7
.3 Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings to stop only
at stations with good signal strength, select M
enu > Scan setting > Strong stations only?
> Yes.
Audio settings
24
To Next Page
Loading...
Need help?
General
