IDENTIFICATION OF THE UNIT
The HH air treatment units come with a rating plate, which shows:
- The manufacturer's address - Supply voltage in "V"
- "CE" marking - Supply frequency in "Hz"
- Model - Number of phases, indicated with "Ph"
- Lot number - Total cooling capacity in "W"
- Date of production - Sensible cooling capacity in "W"
- Rated absorbed current in "A" - Heat output.
- Input in "W"
TRANSPORTATION, RECEIVING, HANDLING
The units and their accessories are enclosed in cardboard boxes up to size 50, while the other sizes are palletised.
The packs should be kept intact until positioned in the final place of installation.
Use suitable handling equipment according to the weight of the unit, as provided for by directive 89/391/EEC and
subsequent amendments.
The weight of each single machine is given in this guide (table 2).
Upon receiving the unit, check all the parts for any damage caused in transit. Any damage should be reported to the
carrier by affixing an accepted with reservation on the accompanying note, specifying the type of damage.
In the event of prolonged storage, keep the units protected against dust and far from sources of vibration or heat.
The number of units that may be positioned on one pallet are given in the table (table 1).
SAFETY PROVISIONS
Secure packs during
transportation.
Do not expose to the
elements.
Do not tread on packs.
Protect hands with work gloves
when dismantling the unit.
Work in PAIRS if the
appliance weighs
more than 25 kg.
Tab. 1
N.B.: the units may be stacked up to a maximum of 1.80 m in height
LENNOX CANNOT BE HELD LIABLE FOR DAMAGE DUE TO INCORRECT
HANDLING OR LACK OF PROTECTION AGAINST THE ELEMENTS.
!
INSTALLATION - OPERATING & MAINTENANCE MANUAL
Page 3
To Next Page
Loading...
Need help?
General