UNIT INSTALLATION
RECOMMENDATIONS FOR INSTALLATION!
Before installing the unit, ensure that:
1) the place of installation has sufficient space for carrying out installation as well as routine and extraordinary maintenance work
(see fig. 3). If the unit is installed behind a suspended ceiling, an access should be provided;
2) there are no obstructions for air intake and delivery;
3) the water fittings are of the sizes, in the position and spaced apart as required by the unit;
4) the system pressure does not exceed 8 bar for the water-filled versions;
5) the electricity supply corresponds to the data on the unit rating plate and that there is a circuit breaker switch readily accessible
to the user to cut off the power supply whenever necessary;
6) the circuit breaker is in the OFF position so that there is no voltage on the unit supply line.
!
Fig. 4
Fig. 5
Drill the holes in line with the relative slots for the 6 unit screw anchors (fig. 4). Inject thermosetting resin into the
holes and then insert the screw anchors (fig. 5).
Preliminary operations:
- check that the various unit components are perfectly intact;
- check that the installation accessories and documentation are in the pack;
- place the packed section as close as possible to the place of installation;
- do not place tools or weights of any kind on the packed unit.
Fig. 3
INSTALLATION OF THE AIR TREATMENT UNIT
P
1,5 P
INSTALLATION - OPERATING & MAINTENANCE MANUAL
Page 6
To Next Page
Loading...
Need help?
General