Lennox DVR5-CMNS User Manual

_OVRS Electronic Series
Optional ON/OFF Rocker Switch Wiring
‘1. If any of the original wire as supplied must be replaced,
it must be replaced with Type AWM 105°C - 18 GA. wire.
2. 120V, 60H2 — Less than 3 amps.
Gas Valve enor OT Ageessony
oo ASSEMBLY re ——
en)
‘OPTIONAL
OWOFF SWITCH
‘WALE SWITCH
Factory Wired
Figure 17
Step &. instaliing the Optional Forced AirBlower
Kit Wiring - An outlet box is provided for the
installation of the_FAB-11000r_FAB-1600 forced
air blower kits (optional). Electrical power must
be provided to this box to operate the blower.
Route a 3-wire, 120Vac power line with contro!
switch to the lower left front corner (valve side)
of the appliance. Remove the outlet box by
removing two screws and straightening the tab
on the outlet back. Supply wires are to be con-
nected tc the outlet as shown in Figure 78,
ensuring that the polarity (as determined by the
colors of the wires) is exactly as shown. The
black and red wire loop must be leit intact, with
ihe mating connectors connected. Reinstatithe
outlet box.
IMPORTANT: Ground lead must be connected
to the green screw located on the junction box
over plate. Failure tc de so will prevent ihe
apptianse from operating. The appliance must
be electrically grounded in accordance with local
codes or, in the absence of local codes, the
National Electrical Code, ANSI/NFPA 70-(latest
edition). (In Canada, the current CSA C22-1
Canadian Electrical Code.)
The standard optional forced air blower kit or
blower kit with thermal snap switch, may be
mounted at initial appliance installation or atany
time thereafter. Follow the instructions provided
with the blower Kit.
OFF/ON Blower
‘Wall Switch
ca
id
‘Te Fuse or
La
Circuit Breaker
ov
AC
SOHz White |)
Fireplace.
funetion Box
Blower Wiring Diagram
Ground Wire
Connestion
White
rm Blower
{L ower)
utlet
120 Vac
60 He Bipolar
Terminal
Black Screw
(Supply)
9
Connectors
Red Wire
Figure 18
Note: Supply wires may be alternatively connected to the outiet using the screw terminals, however
the black supply wire must be ganged wired to the same terminal that the pre-wired black wire is
attached to and the white supply wire must be connected to the opposite side of the outlet.
Gas Flex Line Kit, Model _GFLV
Gas Valve
i 96" NPT x96" | SV
| YE x9 Flare Flare Fitting | {Millivot or
‘Shut-Off
Valve
ectronic)
| Ee ~s™
|
ai
¥e" Flex Tubing
' %" Nipple,
Standard .
with all Units
! ~
gas Stub $4" Union
as Stul \
¥& Close Nipple
34" Shut-Dif Valve
Yo" x 9s" Reducer
Figure 19
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TG SCALE.
f i r e - p a r t s . c o m

Lennox DVR5-CMNS Specifications

General

Brand	Lennox
Model	DVR5-CMNS
Category	Fireplace Accessories
Language	English