SERVICE
HS26
UNIT
INFORMATION
Page 1
1996 Lennox Industries Inc.
Corp. 9622−L12
Litho U.S.A.
EARLY/LATE
MODEL SERIES
Revised 04−2002
HS26 SERIES UNITS
The HS26 is a high efficiency residential split−system con
densing unit which features a scroll compressor. Early
model HS26 units (−261,−311,−411, and −461) are available
in sizes ranging from 2 through 3−1/2 tons. Late model
HS26 units (−018, −024, −030, −036, −042, −048 and −060)
are available in sizes ranging from 1−1/2 through 5 tons.
The series is designed for use with an expansion valve in
the indoor unit.This manual is divided into sections which
discuss the major components, refrigerant system, charg
ing procedure, maintenance and operation sequence. In
formation in this manual covers both early and late model
HS26 units.
All specifications in this manual are subject to change.
Late Model
HS26 shown
ELECTRICAL DATA (Early Model)
SPECIFICATIONS (Early Model)
Model No. HS26−261 HS26−311 HS26−411 HS26−461
Outdoor
Coil
Condenser
Fan
HCFC−22 (charge furnished)
Face area (sq.ft.)
Tube diameter (in.)
No. of Rows
Fins per inch
Diameter (in.)
No. of Blades
Motor hp
Cfm
RPM
Watts
Liquid line connection
Suction line connection
HS26−261 HS26−311 HS26−411 HS26−461
Model No.
Line voltage data − 60hz./1 phase
Compressor
Rated load amps
Power factor
Locked rotor amps
Condenser
Fan Motor
Full load amps
Locked rotor amps
Max fuse or c.b. size (amps)
*Minimum circuit ampacity
outer / inner
*Refer to National Electrical Code Manual to determine wire, fuse and disconnect size requirements.
NOTE − Extremes of operating range are plus 10% and minus 5% of line voltage
11.8/5.4 15.9/5.5 15.9/15.3 21.6/20.8
3/8 3/8 3/8 3/8
1.36 1.36 2.0 2.0
20 20 20 20
24 24 24 24
3333
1/6 1/6 1/6 1/6
3150 3150 3000 3230
820 820 820 820
210 210 230 205
7lbs. 11oz. 8lbs. 1oz. 9lbs. 0oz. 11lbs. 3oz.
3/8 3/8 3/8 3/8
3/4 3/4 3/4 11/8
208/230V 208/230V 208/230V 208/230V
11.6 13.5 18.0 20
.96 .96 .96 .97
62.5 76.0 90.5 107
1.1 1.1 1.1 1.1
2.0 2.0 2.0 2.0
25 30 40 45
15.6 18.0 23.6 26.1
*Refrigerant charge sufficient for 25 ft. (7.6 m) length of refrigerant lines.
To Next Page
Need help?
General
