• 30 •
Installation, operation and maintenance / INALTO-IOM-1809-E
WHAT TO DO IF...
There is little outfl owing air
Possible cause: incorrect speed setting on the control panel
Possible remedy: select the right speed
Possible cause: clogged fi lter
Possible remedy: clean the fi lter
Possible cause:
obstruction of the airfl ow on the intake or
delivery line
Possible remedy: remove obstruction
The motor does not turn?
Check that…
... the power supply is switched on
...
the switches or thermostats are in the correct
operating position
...
there is no foreign matter jamming the rotation
of the fan
The unit does not heat/cool as before?
Check that…
... the fi lter and the coil are clean
...
no air has entered the water circuit by blee-
ding from the relative valve
... the installation is correctly balanced
... the boiler/chiller is in proper working order
DISMANTLING THE UNIT
This unit is made to last for many years. Qualifi ed personnel are needed to
dismantle it in all safety. The fi rst operation to be carried out before disman-
tling the unit is to disconnect it once and for all from the electricity supply.
This unit has been made using recyclable materials (copper, aluminium,
brass, plastic) and assembled by screws and push-fi ts to make separation
of the parts easy.
Contact a fi rm specialised in differentiated waste disposal; it is the only
way to be certain of correct recycling and thereby contribute to protection
of the environment.
To Next Page
Loading...
Need help?
General
