Page 1
© 2021 Lennox Industries Inc.
Litho U.S.A.
Corp. 1910-L7
02/2021
ML196DFE
Service Literature
ML196DFE SERIES UNITS
ML196DFE series units are high-efficiency gas fur
naces manufactured with Lennox DuralokPlust alumi
nized steel clamshell-type heat exchangers, with a stainless
steel condensing coil. ML196DFE units are available in
heating input capacities of 44,000 to 110,000 Btuh and
cooling applications from 2 through 5 tons. Refer to Product
Specifications for proper sizing.
Units are factory equipped for use with natural gas. A kit is
available for conversion to LP/Propane operation. All
ML196DFE units are equipped with a hot surface ignition
system. The gas valve is redundant to assure safety
shut-off as required by C.S.A.
The heat exchanger, burners and manifold assembly can be
removed for inspection and service. The maintenance section
gives a detailed description on how this is done.
All specifications are subject to change. Procedures outlined
in this manual are presented as a recommendation only
and do not supersede or replace local or state codes.
WARNING
Electric shock hazard. Can cause injury
or death. Before attempting to perform
any service or maintenance, turn the
electrical power to unit OFF at discon
nect switch(es). Unit may have multiple
power supplies.
Table of Contents
Specifications 2.................................
Optional Accessories 3..........................
Blower Performance Data 4......................
I-Unit Components 5............................
II Placement and Installation 19....................
III-Start-Up 39...................................
IV-Heating System Service Checks 40..............
V-Typical Operating Conditions 44.................
VI-Maintenance 45...............................
VII-Wiring and Sequence of Operation 48...........
VIII-Troubleshooting 49...........................
WARNING
Improper installation, adjustment, alteration, service
or maintenance can cause property damage, person
al injury or loss of life. Installation and service must
be performed by a licensed professional HVAC in
staller (or equivalent), service agency or the gas sup
plier.
CAUTION
As with any mechanical equipment, contact with
sharp sheet metal edges can result in personal in
jury. Take care while handling this equipment and
wear gloves and protective clothing.
To Next Page
Need help?
General