Lennox MPD Series User Manual

LENNOX HEARTH PRODUCTS • MERIT PLUS
®
DIRECT VENT GAS FIREPLACES (MPD33/35/40/45) • INSTALLATION INSTRUCTIONS
34
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
Figure 60
Figure 61: Radiant Panel Models
Figure 62: Louver Face Models
Adjustment Rod Up
(minimum air
opening position)
Air Shutter
Burner Tube
Adjusting Set Screw
Adjustment Rod Down
(fully open position)
sledoM
saG
epyT
RIAYROTCAF
RETTUHS
GNITTES
)mm(in.
.taN23/1)8.O(
.porP61/3)67.4(
.taN23/1)8.O(
.porP61/3)67.4(
MPD35
.taN23/1)8.O(
.porP61/3)67.4(
MPD40
.taN8/1)2.3(
.porP2/1)31(
MPD45
.taN8/1)
2.3(
.porP2/1)31(
MPDR33
MPDT33
Combustible
Finished Wall
Materials
Top of Appliance
Min. 1 in.
(25 mm)
Top of Door Frame
Hood must be installed as shown.
Radiant panel
This area must remain
clear of combustible
materials.
Combustible
material may
touch top of
appliance.
Combustible
materials
NOT allowed
below this point
on face
of appliance.
Header
Spacing
Top Standoff
Combustible
Finished Wall
Materials
Min. 1 in.
(25 mm)
This area must remain
clear of combustible
materials.
Combustible
material may
touch top of
appliance.
Combustible
materials
NOT allowed
below this point
on face
of appliance.
Header
Spacing
Top Standoff
Top of Appliance
Top of Door Frame
Hood must be installed as shown.
Louvers
Step 12. HOOD INSTALLATION
Refer to Figures 61 and 62. All models
must have hoods installed prior to
operating.
On all Radiant Panel units, slide the hood into
the slots on the lower edge of the radiant panel
(Figure 61).
On louvered face units, slide the hood into
the slots on the lower edge of the cabinet top
(Figure 62).
FINISHING REQUIREMENTS
Wall Details
Complete fi nished interior wall. To install
the appliance facing fl ush with the fi nished
wall, position framework to accommodate
the thickness of the fi nished wall (Figures 61
and 62)
See Page 5 for
Cold Climate Insulation and
Page 8 for Clearances.

Lennox MPD Series Specifications

General

Brand	Lennox
Model	MPD Series
Category	Indoor Fireplace
Language	English