EasyManuals Logo
Home>Lennox>Air Conditioner>XC16?024

Lennox XC16?024 User Manual

Lennox XC16?024
19 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
Page 3
I − APPLICATION
XC16 condensing units are available in 2, 3, 4 and 5 ton capac-
ities. All major components (indoor blower and coil) must be
matched according to Lennox recommendations for the com-
pressor to be covered under warranty. Refer to the Engineer-
ing Handbook for approved system matchups.
II − UNIT COMPONENTS
Unit components are illustrated in figure 1.
XC16 PARTS ARRANGEMENT
FIGURE 1
DUAL CAPACITOR
CONTACTOR
OUTDOOR FAN
COMPRESSOR
HIGH
PRESSURE
SWITCH
FILTER DRIER
LOW
PRESSURE
SWITCH
CAUTION
To prevent personal injury, or damage to panels, unit
or structure, be sure to observe the following:
While installing or servicing this unit, carefully stow
all removed panels out of the way, so that the panels
will not cause injury to personnel, nor cause damage
to objects or structures nearby, nor will the panels be
subjected to damage (e.g., being bent or scratched).
While handling or stowing the panels, consider any
weather conditions, especially windy conditions, that
may cause panels to be blown around and battered.
Remove the louvered panels as follows:
1 Remove 2 screws, allowing the panel to swing open
slightly (see figure 2).
Detail
A
Detail C
Detail
B
FIGURE 2
Removing/Installing Louvered Panels
MAINTAIN MINIMUM PANEL ANGLE (AS CLOSE TO PARALLEL WITH THE UNIT
AS POSSIBLE) WHILE INSTALLING PANEL.
PREFERRED ANGLE
FOR INSTALLATION
Detail D
ROTATE IN THIS DIRECTION;
THEN DOWN TO REMOVE PANEL
SCREW
HOLES
ANGLE MAY BE TOO
EXTREME
HOLD DOOR FIRMLY TO THE HINGED
SIDE TO MAINTAIN
FULLY−ENGAGED TABS
LIP
IMPORTANT! Do not allow panels to hang on unit by top tab. Tab
is for alignment and not designed to support weight of panel.
Panel shown slightly rotated to allow top tab to exit (or enter) top
slot for removing (or installing) panel.
2 − Hold the panel firmly throughout this procedure. Ro-
tate bottom corner of panel away from hinge corner post
until lower 3 tabs clear the slots (see figure 2, Detail B).
3 − Move panel down until lip of upper tab clears the top slot
in corner post (see figure 2, Detail A).

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lennox XC16?024 and is the answer not in the manual?

Lennox XC16?024 Specifications

General IconGeneral
BrandLennox
ModelXC16?024
CategoryAir Conditioner
LanguageEnglish

Related product manuals