1. Start the Setup Utility program (See ”Starting the Setup Utility program”.)
2. From the Setup Utility program menu, selet Set Power-On Password
and press Enter.
3. The password dialog box will be displayed. Type the new password, and
press Enter.
4. when prompted to confirm the password, type the password again. If
you type the password correctly, the password will be installed.
To delete a previously set user password, do the following :
Note: When prompted for a password, you must type your supervisor
password.
1. From the Setup Utility program menu, select Set Power-On Password
and press Enter.
2. when you type the user password. a message will display that
Enter Password to confirm current password, Press the current
password , if password is correct. next message will display that Enter
New Password. Press Enter and a message will display that indicates the
password has been disabled.
3. Press any key to contine.
Using Device
Device is used to enable or disable user access to the following device:
USB Functions When this feature is set to Disable,
the device of USB is disabled and will
not be displayed in the system
configuration.
To set Device, do the following:
1. Start the Setup Utility program (see “Starting the Setup Utility program”
on page 16).
2. From the Setup Utility program menu, select Devices.
3. Select USB Setup.
4. Select USB Functions.
5. Select Disable or Enable and press Enter.
6. Return to the Setup Utility program menu and select Exit and then Save
changes and Exit.
Note: If you do not want to save the settings, select Discard Changes
and Exit or Discard Changes. You can set others such as Legach
USB Support, Onboard Audio Contronller, Onboard Ethernet
To Next Page
Loading...
Need help?
General