Lenze GSS Series User Manual

Mechanical installation
Mounting
Specification of the direction of rotation
5
28
Lenze • BA 12.0023 • 9.0
5.2.1 Specification of the direction of rotation
GST GFL
GT-GNG-GST-008.iso/dms GT-GNG-GFL-005.iso/dms
GKR GKS/GKL GSS
GT-GNG-GKR-006.iso/dms GT-GNG-GKS
/
GKL-004-iso
/
dms GT-GNG-GSS-007.iso/dms
Fig. 2 Direction of rotation of the drive
5.3 Mounting
5.3.1 Preparation
 Note!
Thoroughly remove anticorrosion agents from output shafts and flange
faces.
Correcting the oil quantity
If the amount of oil in the gearbox has been increased for the purpose of longtime
storage (see chapter 5.2), the oil must be drained completely and then refilled for the
mounting position provided. The following steps have to be observed:
1. Place receptacle under oil drain plug.
2. Remove breathing / oil filler plug.
3. Completely drain lubricant.
4. Screw in oil drain plug.
5. Fill in amount of oil for the mounting position provided (according to nameplate).
6. Screw in breathing / oil filler plug.

Lenze GSS Series Specifications

General

Brand	Lenze
Model	GSS Series
Category	Engine
Language	English