27
Further documents
Operang instrucons I510-Cabinet
8.4 LED status
LED“RDY”(blue) LED“ERR”(red) Status/meaning
O O No supply voltage.
Mains voltage is switched on, inverter is inialized.
(1 s on, 1 s o)
O Inverter is disabled, ready for operaon.
(0.25 s on, 0.25 s o)
Safe torque o (STO) acve, warning acve.
(0.5 s on, 0.5 s o)
o Inverter disabled.
(0.25 s on, 0.25 s o)
Inverter disabled, warning acve.
Inverter disabled, error acve.
(Lights up briey once every
1.5 s)
Inverter disabled, no DC-bus voltage.
o Inverter enabled.
o The motor rotates according to the specied setpoint
or quick stop acve.
(0.25 s on, 0.25 s o)
Inverter enabled, warning acve.The motor rotates
according to the specied setpoint or acve “Quick
stop” funcon.
(1 s on, 1 s o)
Inverter enabled, quick stop as response to fault
acve.
9 Further documents
For certain tasks, informaon is available in further documents.
Document Contents/topics
Project planning document Fundamental informaon on project planning and ordering the product
Commissioning document Fundamental informaon for the installaon and commissioning of the pro-
duct
Mounng instrucons Fundamental informaon on mounng the product
The documents can be found in the Lenze Doc Finder.
10 Disposal
If pollutants are disposed o improperly, they may cause a lasng damage to human health
and the environment. Thus, electrical and electronic equipment must be collected separately
from unsorted municipal waste so that it may be recycled or disposed of properly.
If available, put the components to the company internal disposal from where it is passed on
to specialised waste management companies.
It is also possible to return the components to the manufacturer. For this purpose, please
contact the customer service of the manufacturer.
More detailed informaon on disposal can be obtained from the corresponding specialist
rms and the competent authories.
The packaging of the component must be disposed of separately. Paper, cardboard and
plascs must be recycled.
11 Glossary
Abbreviaon Meaning
AIE Error acknowledgement (“Acknowledge In Error”)
OFF state Signal status of the safety sensor when it triggers or responds
QSP Quick stop