4
Load the paper stack with the printable side faceup.
•
For one
‑
sided printing, load letterhead faceup with the
header toward the front of the tray.
•
For two
‑
sided printing, load letterhead facedown with the
header toward the back of the tray.
•
Do not slide paper into the tray.
•
Make sure that the stack height is below the maximum
paper
fill
indicator.
Overfilling
may cause paper jams.
5
Insert the tray.
If necessary, set the paper size and type to match the paper
loaded in the tray.
Loading the manual feeder
1
Adjust the edge guides to match the width of the paper that
you are loading.
Note: Make sure that the guides fit snugly against the paper,
but not too tight as to cause the paper to buckle.
2
Load a sheet of paper with the printable side facedown.
Note: Make sure that the paper is loaded straight to avoid
skewed or crooked print.
•
For one
‑
sided printing, load letterhead with the printable
side facedown and the top edge entering the printer first.
•
For two
‑
sided printing, load letterhead with the printable
side faceup and the top edge entering the printer last.
•
Load envelope with the
flap
side up and against the right
side of the paper guide.
3
Feed the paper until its leading edge gets pulled in.
Warning—Potential Damage: To avoid paper jams, do not
force paper into the manual feeder.
Loading the multipurpose feeder
Note: The multipurpose feeder is available only if the optional
650-sheet duo tray is installed.
4
To Next Page
Loading...
Need help?
General
