20
Using the IR Receiver
- The image may be different according to the model.
This allows a remote control sensor to be placed in a custom location. Then that display can control other displays via
an RS-232C cable. Install the IR receiver towards the front of the set.
NOTE
• When you see from the back of the set, if the IR receiver cable does not face front, the signal reception range may
shorten.
• The IR receiver is made with a magnet.It is detachable at the bottom (typical installation) or back (wall installation) of
the set.
• Make sure that you unplug the power cord before connecting or removing the IR Receiver.
IR Receiver cable
To Next Page
Loading...
Need help?
General
