Fail Over
This feature enables automatic switching to another input signal when there is no signal from the current input.
You can set Mode to Off, Auto, or Manual.
Off: Fail Over is disabled.
Auto: If there is no signal from the current input, the product input switches to a different input that has a
video signal following a specified order (*see table).
Manual: You can set switching priorities for inputs when there is no signal. If there are a multiple video signals,
the current input switches to the input with the highest priority.
You can set USB to O, Movie, or Photo.
Off: Fail Over USB is disabled.
Movie: If you set this feature to Auto, a movie is played back when there is no input signal. If you set this fea-
ture to Manual, a movie is played back when there is no signal from any of the prioritized inputs.
Photo: If you set this feature to Auto, a photo slideshow is played back when there is no input signal. If you set
this feature to Manual, a photo slideshow is played back when there is no signal from any of the priori-
tized inputs.
Fail Over priority when set to Auto
Current source 1st change 2nd change 3rd change 4th change 5th change
RGB HDMI DVI-D OPS USB Auto play RGB NO SIGNAL
DVI-D HDMI OPS RGB USB Auto play DVI NO SIGNAL
HDMI DVI-D OPS RGB USB Auto play HDMI NO SIGNAL
OPS HDMI DVI-D RGB USB Auto play OPS NO SIGNAL
LG Digital Signage Setup
USB Cloning
Password Change
Set ID Setup
Configuration Setup
Lock Mode
External Speaker
Fail Over
ISM Method
Easy Brightness Control
S/W : xx.xx.xx.xx Micom : x.xx.x
OK
Installation Menu (V 3.0)
Fail Over
Fail Over
Mode
USB
Priority1
Priority2
Priority3
Priority4
-----
-----
Off
OK
Previous
-----
-----
Off
To Next Page
Loading...
Need help?
General
