Using the Input List
1
Press INPUT to access the Input List.
2
Press the navigation buttons to scroll to one of the input mode and press OK.
USING THE MONITOR
• You can also change the image size by accessing the main menus.
• The Just Scan mode operates when a video signal has resolution of 720p or higher.
• Some input signals may not be supported depending on the model.
Adjusting Aspect Ratio
Resize the image to view the image at its optimal size by pressing ARC while you are watching monitor set.
• If a fixed image displays on the screen for a long period of time, it will be imprinted and become a
permanent disfigurement on the screen. This is image burn or burn-in and not covered by the warranty.
• If you don't use your monitor, turn the power off or set a screen saver program from the PC or the system to
prevent image retention.
• If the aspect ratio is set to 4:3 for a long period of time, image burn may occur on the letterboxed area of the
screen.
MODE
Aspect Ratio
RGB HDMI DVI-D Display Port OPS
PC DTV PC DTV PC DTV PC DTV PC
16:9
o o o o o o o o o
Just Scan x o x o x o x o x
Set By Program x o x o x o x o x
4:3 o o o o o o o o o
Zoom x o x o x o x o x
Cinema Zoom1 x o x o x o x o x
y
RGB-PC
y
HDMI
y
DVI-D
y
USB
y
Display Port
y
OPS
NOTE
NOTE
CAUTION
To Next Page
Loading...
Need help?
General
