Standard Repair Process Detail Technical Manual
Sequence of the Vcom adjustment
D. VCOM Adjustment
1. Case
■
LCD module change
■
T-Con board change
2. Equipment
■
Service Remote controller
3. Adjust sequence
■
Press the ‘adj’ key
■
select V-COM
■
As pushing the right or the left button on the remote controller, And find the V-COM value Which is no or
minimized the Flicker.
(If there is no flicker at default value, Press the exit key and finish the VCOM adjustment.)
■
Push the OK key to store the value. Then the message “Saving OK” is pop.
■
Press the exit key to finish V-COM adjustment.
A28
Established
date
Revised
date
Error
symptom
Content
LCD TV
2010. 12 .14
To Previous Page
Loading...
Need help?
General
