Operating24
Operating
3
Radio Operations
Be sure that both FM aerials are connected. (Refer to
page 15)
Listening to the radio
1. Press F / WIRELESS BOOM on the unit or F on
the remote control until FM appears in the display
window.
The last received station is tuned in.
2. Auto tuning :
Press and hold TUNING-/+ on the remote
control for about two seconds until the frequency
indication starts to change, then release. Or press
SEARCH and then rotate Y SEARCH U on
the unit. Scanning stops when the unit tunes in
a station.
Or
Manual tuning :
Press TUNING-/+ on the remote control
repeatedly or rotate Y SEARCH U on the
unit.
3. Adjust the volume by rotating volume knob on
the unit or by pressing VOL +/- on the remote
control repeatedly.
Improving poor FM reception
Press T on the unit or d/M on the remote control.
This will change the tuner from stereo to mono and
usually improve the reception.
Presetting the Radio Stations
You can preset 50 stations for FM.
Before tuning, make sure to turn down the volume.
1. Press F / WIRELESS BOOM on the unit or F on
the remote control until appears in the display
window.
2. Select the desired frequency by pressing
TUNING -/+ on the remote control or by rotating
Y SEARCH U on the unit.
3. Press JUKEBOX/MEMORY on the remote
control. A preset number will blink in the display
window.
4. Press PRESET·FOLDER W/S on the remote
control to select the preset number you want.
5. Press JUKEBOX/MEMORY on the remote
control. The station is stored.
6. Repeat steps 2 to 5 to store other stations.
7. To listen a preset station, press
PRESET·FOLDER W/S or 0 to 9 numerical
buttons on the remote control.
Deleting all the saved stations
1. Press and hold JUKEBOX/MEMORY on the
remote control for two seconds.
“ERASEALL” will flash up on the unit display.
2. Press JUKEBOX/MEMORY on the remote
control to erase all the saved radio stations.
To Next Page
Loading...
Need help?
General
