Insert the front rail between the bottom of the dryer and the top of the washer. Push the front rail toward the back of
the washer until it comes in contact with the side rail stoppers.
Install the two retaining screws to secure the front rail to the side rails.
LG DLEX4000 Ultra Large Front Load Electric Dryer-5
Venting the Dryer
WARNING
To reduce the risk of fire or explosion, electric shock, property damage, injury to persons or death when
using this appliance, follow basic safety precautions, including the following:
Do not crush or collapse ductwork.
Do not allow ductwork to rest on or contact sharp objects.
If connecting to existing ductwork, make sure it is suitable and clean before installing the dryer.
Venting must conform to local building codes.
Gas dryers MUST exhaust the outdoors.
Use only 4-inch (10.2 cm) rigid, semi-rigid or flexible metal ductwork inside the dryer cabinet and for venting
outside.
To reduce the risk of fire, combustion, or accumulation of combustible gases, DO NOT exhaust dryer air into an
enclosed and
unventilated area, such as an attic, wall, ceiling, crawl space, chimney, gas vent, or concealed space of a
building.
To reduce the risk of fire, DO NOT exhaust the dryer with plastic or thin foil ducting.
The exhaust duct must be 4-inch (10.2 cm) in diameter with no obstructions. The exhaust duct should be kept
as short as possible. Make sure to clean any old ducts before installing your new dryer.
To Next Page
Loading...
Need help?
General
