NOTE
• If you are installing the dryer on the optional pedestal, you must use the leveling feet on the pedestal to level
the dryer. The dryer leveling feet should be fully retracted.
2. Use an adjustable wrench to turn the leveling feet. Unscrew the legs to raise the dryer or screw in the legs to
lower it. Adjust the leveling feet until the dryer is level from side to side and front to back. Make sure that all four
leveling feet are in firm contact with the floor.
Reversing the Door
Tools Required
Phillips screwdriver
Large flat-blade screwdriver (recommended for hinge screws if they are tight or your Phillips screwdriver is
worn)
Small flat-blade screwdriver (for lifting out parts)
WARNING
To reduce the risk of damage to the dryer, property damage, or personal injury, follow basic precautions, including
the following:
Support the door with a stool or box that fits under the door, or have an assistant support the weight of the
door.
Avoid dropping the door.
Unplug the dryer or turn off the power at the main circuit breaker before beginning door reversal.
Always reverse the door BEFORE stacking the dryer on top of the washer.
Door Reversal Instructions
The instructions here are for changing the door swing from a right to a left side hinge. If the door has been reversed,
and it is necessary to change it back, use care when following these instructions. Some of the illustrations and the
left/right references will be reversed, and you will need to read the instructions carefully.
WARNING
Be sure to support the weight of the door before removing the hinge screws.
1. Open the door and remove the two decorative screws, two latch screws, and the latch on the catch side
To Next Page
Loading...
Need help?
General
