1 To register automatically, turn the
TV on and press the Wheel(OK)
button. When registration is
completed, the completion
message appears on the screen.
2 If registration fails, turn the TV
off and back on, then press the
Wheel(OK) button to complete
registration.
How to re-register the Magic Remote Control
BACK
SMART
1 Press and hold the BACK
and
SMART
buttons together for 5
seconds to reset, then register it
by following “How to register the
Magic Remote Control” above.
2 To re-register the Magic Remote
Control, press and hold the
BACK
button for 5 seconds
toward the TV. When registration
is completed, the completion
message appears on the screen.
How to use Magic Remote
Control
1 If the pointer disappears, move
the Magic Remote Control
slightly to left or right. Then, it
will automatically appear on the
screen.
»
If the pointer has not been used
for a certain period of time, it will
disappear.
2 You can move the pointer by
aiming the Pointer Receiver of the
Magic Remote Control at your TV
then move it left, right, up or down.
»
If the pointer does not work
properly, leave the Magic
Remote Control for 10 seconds
then use it again.
1
If you press Wheel(OK) on the Magic Remote
Control, the following screen appears.
Shows information about the current programme
and screen.
2
You can select More Menu.
More
11-1 Brief Info Title Test...
Info.
Precautions to Take when Using
the Magic Remote Control
y
Use the Magic Remote Control within the maximum
communication distance (10 m). Using the Magic
Remote Control beyond this distance, or with an
object obstructing it, may cause a communication
failure.
y
A communication failure may occur due to nearby
devices. Electrical devices such as a microwave
oven or wireless LAN product may cause
interference, as these use the same bandwidth (2.4
GHz) as the Magic Remote Control.
y
The Magic Remote Control may be damaged
or may malfunction if it is dropped or receives a
heavy impact.
y
Take care not to bump into nearby furniture or
other people when using the Magic Remote
Control.
y
Manufacturer and installer cannot provide service
related to human safety as the applicable wireless
device has possibility of electric wave interference.
y
It is recommended that an Access Point (AP) be
located more than 1 m away from the TV. If the
AP is installed closer than 1 m, the Magic Remote
Control may not perform as expected due to
frequency interference.
To Next Page
Loading...
Need help?
General
