26 INSTALLATION
If the space between the doors is uneven, follow
the instructions below to align the right door:
1 With one hand, lift up both the inner and
outer door sections of the right door to raise
them at the middle hinge. (It may be easier to
lift it with the doors open.)
2 With the other hand, use pliers to insert the
snap ring on the middle hinge of the inner
door section as shown. Do not insert the ring
on the hinge of the outer door section.
3 Insert additional snap rings until the right
door is aligned. (Two snap rings are provided
with the unit.)
Turning on the Power
• After installing, plug the refrigerator’s power
cord into a 3-prong grounded outlet and push
the refrigerator into the final position.
• Connect to a rated power outlet.
• Have a certified electrician check the wall outlet
and wiring for proper grounding.
• Do not damage or cut off the ground terminal of
the power plug.
Position the Refrigerator
• Arrange the coil of tubing so that it does not
vibrate against the back of the refrigerator or
against the wall. Push the refrigerator back to
the wall.
Start the Icemaker
• If the water line is connected, set the icemaker
power switch to the ON position.
• The icemaker will not begin to operate until it
reaches its operating temperature of 15 °F (–9
°C) or below. It will then begin operation
automatically if the icemaker power switch is in
the ON (I) position.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
