Operating 31
Operating
3
Using Microphone
1. Connect your microphone to the MIC jack.
2. Play the music you want.
3. Sing along with the accompaniment. Adjust the
microphone volume by pressing MIC VOL -/+ on
the unit.
y When not using the microphone, set the MIC
volume to minimum or turn off the MIC and
remove the microphone from the MIC jack.
y If the microphone is set too near the speaker,
a howling sound may be produced. In this
case, move the microphone away from the
speaker or decrease the sound level by using
the MIC VOL - on the unit.
y If sound through the microphone is extremely
loud, it may be distorted. In this case, set the
microphone volume by pressing MIC VOL -.
y You can give an echo effect to the sound
from the microphones by pressing
MIC ECHO on the remote control or MIC
ECHO / DEMO on the unit.
,
Note
VOICE CANCELLER
You can reduce the vocal tones during music
playback from various input sources.
Press the VOICE CANCELLER on the remote control
and “ON-VOICE CANCELLER” will appear in display
window.
To cancel it, press VOICE CANCELLER on the
remote control again.
The quality of the VOICE CANCELLER may be
different depending on the recording conditions of
music les.
y This function is available in the CD, USB or BT
(Bluetooth) Function.
y If the function is not available, “NOT
SUPPORT” appears in the display window.
y This function is available to use only when a
microphone is connected.
y If a microphone is not connected, “INSERT
MIC” appears in the display window.
y It is not available on the mono source.
y To initialize it, change the function or
disconnect the microphone.
y This function may not be initialized depending
on the status of connected devices.
,
Note
To Next Page
Loading...
Need help?
General
