16
PREPARATION
Installation
Installation Precautions
y
Place the projector in a well-ventilated
environment.
- To prevent internal heat build-up,
install the projector in a well-
ventilated place.
Do not place anything near the
projector as this may block its air
vents. If the air vents are blocked,
the internal temperature will
increase.
- Do not place the projector on a
carpet or rug. If the vent is on the
bottom, use the projector on a solid
level surface
and ensure the vent
is
not blocked.
- Be sure to prevent foreign objects
such as paper debris from entering
the projector.
- Leave enough distance (30 cm or
more) around the projector.
y
Do not place the projector in a hot
or humid environment.
- Do not place the projector in a hot,
cold, or humid environment.
y
Do not place the projector in a place
where it will easily attract dust.
- This may result in fire.
y
Never open any cover on the
projector. There is a high risk of
electric shock.
y
The projector is manufactured using
high-precision technology. You may,
however, see tiny black dots and/
or bright colored dots (red, blue or
green) that continuously appear on
the projector screen. This is a normal
result of the manufacturing process
and does not indicate a malfunction.
y
The remote control may not work
in an environment where a lamp
equipped with electronic ballasts or
a three-wavelength fluorescent lamp
is installed. Replace the lamp with an
international standard lamp for the
remote control to work normally.
y
To adjust the angle of the projector,
turn the adjustment legs to the left or
right while pressing on the rubber part
at the same time.
To Next Page
Loading...
Need help?
General
