21
PREPARATION
Installation
InstallationPrecautions
• Place the projector in a well-
ventilated environment.
- To prevent internal overheating,
install the projector in a well-
ventilated place.
Do not place anything near
the projector that may block
its air vents. If the air vents
are blocked, the internal
temperature of the projector will
increase.
- Do not place the projector
on a carpet or rug. If the
projector's inlet vent is on
the bottom, be careful not to
block the vent and always
use the projector on a solid,
level surface.
- Be sure to prevent foreign
objects such as paper debris
from entering the projector.
- Leave an adequate open
area (30 cm or more) around
the projector.
• Do not install the projector in a
hot or humid environment.
- Only install the projector
in a place of moderate
temperature and low
humidity.
• Do not install the projector in a
place where it can attract dust.
- There is a risk of re.
• Never open any cover on the
projector. There is a high risk of
electric shock.
• This projector is manufactured
using high-precision technology.
You may, however, see tiny
black dots and/or bright colored
dots that continuously appear
on the projector screen.
This is a normal result of the
manufacturing process and
does not indicate a malfunction.
• The remote control may not
work in an environment where
a lamp equipped with electronic
ballasts or a three-wavelength
fluorescent lamp is installed.
Replace the lamp with an
international standard lamp
for the remote control to work
normally.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
