To Next Page

To Previous Page

PROGRAMMING MODE

PROGRAMMING MODE - Setup Mode

Setup Mode : (display)

■ You can change dryer vend price, cycle time, and cycle parameters, etc.

■ Entering set up mode

• Coin type - Turn on/off toggle switch.

• Card type - Insert the service card.

• Stack type - Take off control panel, and turn on/off toggle switch.

• OPL/Coin Type – Push “High Temp.” + “Low Temp.” and the ‘3’.

• Then, dryer displays

1. How to change regular price.

• rgCP (regular cold price) is not available in dryer.

• rgrP (regular warm price) is not available in dryer.

• rgHP (regular hot price) is not available in dryer.

NOTE

Entering set up

mode.

You will see LqC1

Button Display

Press the High Temp. button.

Press the Med Temp. or the Low Temp. button until

appears in the display.

Press the Start button.

Display previous regular price.

Press Med Temp.(+) or Low Temp.(-) button to set regular price.

(The vend price can be set from 0 to 9,90 in 0.1 increments.)

Press the Start button.

The machine sets up the regular price, then advances to the

next process automatically.

1. Continue to set up the next price.

2. Stop the change of setup value and go back to ready mode.

• Coin type - Turn on/o toggle switch.

• Card type - Pull the service card.

• Stack type - 1. Control panel open.

2. Turn on/o toggle switch.

• OPL/Coin Type – Press “High Temp.” twice.

MFL62512875_150414.indd 19 2015.4.14 9:43:41 AM

LG RV1329AD1 User Manual

Questions and Answers: