37
PROGRAMMING MODE
15. Product type setup – coin/card type or OPL setup
Entering set up
mode.
You will see LqC1
Button Display
Press the High Temp. button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Press the Med Temp. or the Low Temp. button until
appears in the display.
Press the Start button.
Display previous value.
Press Med Temp. or Low Temp. button and then select
or .
Coin/Card type setting
OPL type setting
One or the other will
display.
Press the Start button.
The machine sets up the time to keep the coin, then advances to
the next process automatically.
1. Continue to set up the next mode.
2. Stop the change of setup value and go back to ready mode.
• Coin type - Turn on/o toggle switch.
• Card type - Pull the service card.
• Stack type - 1. Control panel open.
2. Turn on/o toggle switch.
• OPL/Coin Type - Press “High Temp.” twice.
MFL62512875_150414.indd 37 2015.4.14 9:44:1 AM
To Next Page
Loading...
Need help?
General
