To Next Page

To Previous Page

PROGRAMMING MODE

• PrSH (Pre-wash apply or not) is not available in dryer.

NOTE

3-3. Sensor dry apply or not setup (Use only for OPL type)

Entering set up

mode.

You will see LqC1

Button Display

Press the High Temp. button.

Press the Med Temp. or the Low Temp. button until

appears in the display.

Press the Start button.

Press the Med Temp. or the Low Temp. button until

appears in the display.

Press the Start button.

Display

Press the Med Temp. or the Low Temp. button until

appears in the display.

Press the Start button.

Press Med Temp. or Low Temp. button and then select

or .

Disable

Enable

One or the other will

display.

Press the Start button.

The machine sets up the Vend type, then advances to the next

process automatically.

1. Continue to set up the next mode.

2. Stop the change of setup value and go back to ready mode.

• Coin type - Turn on/o toggle switch

• Card type - Pull the service card

• OPL/Coin type – Press “High Temp.” twice

MFL67863709_en_170328.indd 24 2017-03-28 �� 9:54:27

LG TCD1870QGS User Manual

Other manuals for LG TCD1870QGS