Installation Instructions
lacing and Leveling
P
16
Top view of the machine
Caster
Leg Stopper
more than 4”
more
than
1”
more than
1”
Place the machine on a flat and firm surface which allows proper clearance.
Concreate flooring is best. Washer should not be installed
on rugs or exposed to the weather.
We suggest a minimum clearance of 1” from right and left
sides and 4” from rear wall.
An insecure installation may cause walking during spin cycles because the washer has casters for
convenience to move.
To protect it from walking, place the leg stoppers, which are provided as a accessory, under the two
front legs of washer as shown in the figure.
Check that the machine is level and
securely installed not to move.
Open the lid and look from above to see if it is
same as shown beside.
1
2
Please ensure that the transit restraint has been removed before operating your
machine.
Caution
If the washer is installed on a uneven,weak or tilted floor causing excessive vibration,
spin failure or “ ” error can happen to it.
It must be placed on a firm and level floor to prevent spin failure.
■ Washer with Casters
To Next Page
Loading...
Need help?
General
