MAINTENANCE
5
Wipe off any moisture with a dry towel or cloth
after cleaning.
6
Replace the detergent dispenser drawer.
WARNING
% Do not spray water inside the cabinet. Doing so
may cause re or electric shock.
Cleaning the Door Seal
Clean the door seal once a month to prevent build-up
of dirt.
1
Wear rubber gloves and protective goggles.
2
Dilute 3/4 cup (177 ml) of liquid chlorine
bleach in 1 gallon (3.8 L) of water.
3
Wipe around the door seal.
Soak a sponge or a soft cloth in this diluted
solution and wipe all around the door seal.
4
Wipe dry.
After cleaning, wipe up any moisture with a dry
towel or cloth.
5
Leave the door open to allow the door seal to
dry completely.
CAUTION
% Cleaning the door seal with undiluted bleach
may cause malfunction of the door seal and
washer parts. You must add water to the bleach
before using it.
Cleaning the Water Inlet
Filters
If the washer does not ll properly, an error message
will show on the display. The inlet valve lter screens
could be plugged by hard water scale, sediment in
the water supply, or other debris.
CAUTION
% The inlet screens protect the delicate parts of
the inlet valve from being damaged by particles
that could enter the valves with the water supply.
Operating the washer with these lters removed
could cause a valve to stick open resulting in
ooding and/or property damage
% If you use the washer in an area with hard water,
the inlet lter may clog due to lime buildup.
1
Turn off both water faucets completely.
2
Unscrew the hot and cold water hoses from
the back of the washer.
3
&DUHIXOO\UHPRYHWKH¿OWHUVIURPWKHZDWHU
valves.
4
5HPRYHIRUHLJQREMHFWVDQGVRDNWKH¿OWHUVLQ
white vinegar or a lime scale remover.
If using a lime scale remover, follow the
manufacturer’s instructions. Be careful not to
damage the lters while cleaning them.
5
5LQVH¿OWHUVWKRURXJKO\DQGSUHVVWKHPEDFN
into place.
6
Flush then reattach the water hoses.
Before reattaching the hoses, ush the hoses and
water lines by running several gallons of water
into a bucket or drain, preferably with the faucets
wide open for maximum ow.
NOTE
% An
message may blink on the display when the
water pressure is weak or an inlet lter is clogged
with dirt. Clean the inlet lter.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
