EasyManuals Logo
Home>Linksys>Wireless Router>E2000

Linksys E2000 User Manual

Linksys E2000
59 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Linksys E2000 Chapter 1: Product Overview
5
Advanced Wireless-N Router
Placement Positions
There are two ways to physically install the Router. The
first way is to place the Router horizontally on a surface.
The second way is to mount the Router on a wall.
Horizontal Placement
The Router has four rubber feet on its bottom panel. Place
the Router on a level surface near an electrical outlet.
Wall-Mounting Placement
The Router has two wall-mount slots on its bottom panel.
The distance between the slots is 152 mm (6 inches).
Two screws are needed to mount the Router.
Suggested Mounting Hardware
2.5-3.0 mm
4-5 mm 1-1.5 mm
Note: Mounting hardware illustrations are not true
to scale.
NOTE: Cisco is not responsible for damages
incurred by insecure wall-mounting hardware.
Follow these instructions:
1. Determine where you want to mount the Router. Make
sure that the wall you use is smooth, flat, dry, and
sturdy. Also make sure the location is within reach of
an electrical outlet.
2. Drill two holes into the wall. Make sure the holes are
152 mm (6 inches) apart.
3. Insert a screw into each hole and leave 3 mm
(0.12 inches) of its head exposed.
4. Maneuver the Router so the wall-mount slots line up
with the two screws.
5. Place the wall-mount slots over the screws and slide
the Router down until the screws fit snugly into the
wall-mount slots.
152 mm
Wall Mounting Template
Print this page at 100% size.
Cut along the dotted line, and place on the wall to drill precise spacing.

Table of Contents

Other manuals for Linksys E2000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Linksys E2000 and is the answer not in the manual?

Linksys E2000 Specifications

General IconGeneral
Ethernet LANYes
Networking standardsIEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.3, IEEE 802.3ab, IEEE 802.3u
Ethernet LAN data rates10, 100, 1000 Mbit/s
Ethernet LAN interface typeGigabit Ethernet
Input current1 A
Input voltage12 V
Dimensions (WxDxH)202 x 34 x 160 mm
WLAN data transfer rates supported300 Mbit/s
DHCP client-
Antennas quantity3
Antenna gain level (max)2.2 dBi
Web-based managementNo
Security algorithmsWEP, WPA, WPA2
CertificationFCC, CE, IC-03, Wi-Fi
Storage temperature (T-T)-20 - 60 °C
Operating temperature (T-T)0 - 40 °C
Storage relative humidity (H-H)5 - 90 %
Operating relative humidity (H-H)10 - 85 %
Cables includedLAN (RJ-45)
Weight and Dimensions IconWeight and Dimensions
Weight300 g

Related product manuals