Match Source IP
Permit or deny packet by source IP address.
If the ACL type is IPv4, set an IPv4 address
and its wildcard mask.
Note—Wildcard 0 means to match that value, 1
means don’t match. For example, a mask of 0000
0000 0000 0000 0000 0000 1111 1111 which
means that you match on the bits where there is 0
and don't match on the bits where there are 1s. You
need to translate the 1s to a decimal integer and you
write 0 for each four zeros. In this example since
1111 1111 equals to 255, the wildcard mask would
be written as 0.0.0.255. To match traffic by source
IP address from 192.168.2.0 to 192.168.2.254,
enter the source IP as 192.168.2.0 and wildcard
mask as 0.0.0.255. To match a specific source IP
address e.g. 192.168.2.100, enter the source IP as
192.168.2.100 and wildcard mask as 0.0.0.0.
If the ACL type is IPv6, set an IPv6 address
and its prefix length. The range for IPv6 prefix
length is 0 to 128.
Match Source Port
Permit or deny packet by a source port identified in
the datagram header.
Select from List
FTP – Port 21
FTP Data – Port 20
HTTP – Port 80
SMTP – Port 25
SNMP – Port 161
Telnet – Port 23
TFTP – Port 69
Match to Port
Enter a single destination port number for matched
packets. The port range is 0-65535.
79
To Next Page
Loading...
Need help?
General
Weight and Dimensions
