6
lci1.com 574-537-8900 Rev: 05.30.19
Solera
®
Slider
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0001264
10. Fasten the extension rods to the extension rod brackets
by installing two of the provided #10 - 16 x ¾” self drilling
hex washer head screws in each extension rod bracket
(Fig.7A).
A
Fig.7
ROLL TUBE SPRINGS ARE UNDER TENSION.
IMPROPERLY SECURED ROLL TUBE SPRINGS CAN
CAUSE PERSONAL INJURY AND/OR PRODUCT
DAMAGE. SLOWLY RELEASE SPRING TENSION
TO AVOID PERSONAL INJURY AND/OR PRODUCT
DAMAGE.
11. Firmly hold the roll tube when removing the spring clip
to relieve spring tension.
Securing the Fabric
1. Extend and retract the room several times to ensure that
the fabric is square on the roll tube.
2. Secure the fabric in the awning rail no more than 1”
inside the edge of the fabric on both ends using a #6 x ½”
hex head screw. Install the screw down through the awning
rail into the fabric and the polycord (Fig.8).
awning rail
1"
fabric stitching
Fig.8
Maintenance
Fabric Care
If the awning is retracted while wet, extend the awning
and let it dry as soon as conditions allow before
retracting. This will help prevent the formation of mildew
and add greatly to the life of the awning. Mildew does not
form on the fabric itself, but on the accumulated dust, dirt
and grime.
Periodically clean vinyl or woven acrylic fabric using a
mixture of ¼ cup of dish soap and 5 gallons of warm
water. Liberally apply the mixture on the top of the fabric
and retract the awning for five minutes. This will apply
the mixture to the bottom of the fabric as well. Extend the
awning and hose off with fresh water. Repeat if necessary.
Allow fabric to dry before retracting.
To Next Page
Loading...
Need help?
General
