GB
16
Connections
Connecting the Aerial
Connect one end of the RF coaxial cable to the aerial
socket on the wall and the other end of the cable to
the RF (75Ω) socket at the rear right side of your TV.
HDMI1
USB
PC AUD IO
VGA RF
SCART
OR
RF coaxial cable
(not included)
Do not connect the TV to the mains
supply until you have completed all the
connections.
Connecting a USB Storage Device
1. Switch off the TV before connecting any USB storage
device.
2. Connect your USB storage device to the USB port of
your TV.
3. Press the
button on the right side panel of the TV
or on the remote control to turn on your TV and your
USB storage device.
4. Press the
button on the right side panel of the TV
or the INPUT button on the remote control to display
the Source List. Use the
buttons to select DMP
and then press the OK button to confirm.
• If a hard disk is used, make sure its mains adapter is connected to the mains supply.
• If a USB hub is used, make sure its mains adapter is connected to the mains supply as the total current consumption
may exceed 500mA.
• The maximum supported storage space of the hard disk is 250 GB.
• The file system only supports FAT32 format.
• If you want to store the video streaming of a DTV programme, the transfer rate of the USB storage device must not
be less than 5MB/s, otherwise the picture and sound of the programme will be affected and a warning statement
will be shown on the screen. If this happens, please upgrade your USB storage device.
• The TV screen will be blank temporarily as it will take time to start up and stabilise the connected hard disk. This is
normal and the starting time may vary depending on the brand and the memory size of the connected hard disk.
• Disconnect the USB storage device if it is not in use.
Rear Right Side View of TV
HDMI1
USB
PC AUDIO
VGA RF
SCART
USB Cable
(not included)
Adapter
Portable
hard Disk
USB Hub
USB
To Next Page
Loading...
Need help?
General
